Pricing

Rollexx Stern Thruster

The Rollexx Stern Thruster ships to you complete with everything you need for installation!

  • Stainless steel 10 hp 240 vac motor with 15“ diameter composite propeller
  • Two stainless steel motor mounts with cushions
  • One variable frequency drive motor control
  • One circuit breaker in enclosure
  • One junction box for the thruster motor termination
  • One joystick (you could have two more at additional cost *)
  • One rudder position sensor
  • One flexilink
  • One on-off switch (illuminated when on)
  • Two tubes of underwater sealant
  • All control wiring with connectors installed
  • Four conductor #6 thhn cable rated for wet, oily and hazardous locations to run from your generator to the motor control as well as from the motor control to the Rollexx Stern Thruster

You simply measure the wiring lengths after you determine where you are going to mount everything, give us the dimensions, then we install all the connectors on the cables for you!

It’s as close to plug and play as possible, the only extras you need to provide are miscellaneous mounting nuts, bolts, screws, etc!

* Additional joysticks with cabling are available for $475 each and must be included with the original Rollexx order!

$19,750

boat stabilizers price

How To Order Rollexx

Call us at 800-772-6165

  1. We need to know a little about the boat the Rollexx will be installed on since it won’t fit all boats.
  2. We need to have a discussion relating to safety and proper operation of the Rollexx Stern Thruster to make sure you are familiar with the potential hazards of a person coming into contact with the Rollexx while it is in operation!
  3. Download the pdfPurchase Order and Hold Harmless Agreement. You’ll be able to type in these documents on your computer and save them. Then print, sign and return them to us with a deposit of $2,000.00 check, money order or credit card to secure your position in our production line!

Maintenance

Zinc/Propeller Locking Nut Assembly

The Zinc/Propeller Locking Nut Assembly is proprietary to the Rollexx. The zinc protects the motor shaft and internals and is a very important routine maintenance item! You should keep 1 or 2 in stock for your diver to access when needed.

The Rollexx Zinc/Propeller Locking Nut Assembly is constructed of a stainless steel threaded core with 99% pure zinc making up the balance of the 1-5/8″ dia x 2-1/8″ long assembly plus a 7/8″ hex nut and center lock set screw.

To order spares simply call or email with credit card info, we will get the zinc right out to you!

$65

Rollexx Stern Thruster
800-772-6165
International: 1+ 661-822-9311

G. Northcutt Corp
20843 Santa Lucia St. #C
Tehachapi, CA 93561
rollexx@boat-stabilizer.com
$19750

© 2019 G. Northcutt Corp — All rights reserved
Website developed by Sparks Arts